![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Apr 4, '05 From ST PAUL, MN Currently Offline Reputation: 3 (100%) ![]() |
ok just got done putting my 3rd gen map in, been running the 2nd gen map for a bit now...i do have a st205 motor and ecu...so yeah clearing that up now...on my 2nd gen map i can boost fine but i bogg out at like 5500rpm and it climbs up again and then boggs..i have put a third gen map in, off my buddys mr2..and my car ran fine..now that i have my own when try to boost..i dont boost and im running hella lean!!!damn it scared the living crap out of me.. here is the part number 8942020310-100798310050v..any clue of what could be the problem??
it is the right map sensor...but have no clue why i cant boost hard and run hella lean when i do..ooh yeah i did reset the ecu too.. This post has been edited by RUNNIN-LOW: Sep 22, 2008 - 2:47 PM -------------------- ![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Apr 4, '05 From ST PAUL, MN Currently Offline Reputation: 3 (100%) ![]() |
alright just took the car out for another drive...man the thing pulls hard...re adjusted the fpr nothing is wrong with it..figure that the wideband was reading everything wrong..checked the downpipe and now i finally realise how much i hate ebay stuff...had a 2in crack on the downpipe..but yeah turbo upgrading so takin car apart today..thanks everyone for the help...
-------------------- ![]() |
![]() ![]() |
Lo-Fi Version | Time is now: February 20th, 2025 - 12:11 PM |