FS: Lots Of Parts For Sale!!!, EDIT: Prices Lowered!!!!! Options

[6strngs]

Got a new car, and basically anything I can't use on it is for sale, so here we go:

Custom oil filter relocation kit including canton racing engine side adaptor, 36 inch long stainless braided Russell hose, Summit hose ends, and a Trans-dapt filter side adaptor $195 shipped

SSAC ebay 3" downpipe. never cracked on me. wrapped in heat wrap and painted flat black with a high temp silicone paint. I'm sad my new car doesn't have a twin entry turbo otherwise I'd be using this already. It has 3 o2 sensor bungs. one primary stock one, one for the stock secondary sensors (CA spec and 96+) and one for a wideband. I'll include a plug for one if I can find it. $85 shipped


Custom made stainless steel oil feed and drain line. comes with an oil pan with a fitting already welded onto it. $110 shipped


Custom made 3" intake for 5sfte set-ups, includes nipple so you can connect your PCV line $40 shipped


FMIC, 26x6x2.5 -ish (not sure exact dimensions but can measure for you) all piping, couplers and clamps have been sold already. $85 shipped


Fidanza lightweight flywheel for manual transmission 5sfe's $210 shipped sale pending


3sgte 7-bolt twin entry manifold SOLD!
460cc RX7 injectorsSOLD!
TWM short throw shifter SOLD!
Piping, couplers, clamps SOLD!
Walbro Fuel Pump, GSS-342 with 400-765 install kit SOLD!
coolant lines for the CT-26 SOLD!
3sgte 2bar map sensor SOLD!
Lotek A-pillar 3-gauge pod SOLD!
Kirk-o-saurus polyurethane motor mount inserts SOLD!
Dodge neon front strut bar modified to fit 6GC SOLD!
Tein S-tech springs SOLD!
I think that's everything...

This post has been edited by 6strngs: Oct 9, 2008 - 11:42 PM

[Etak28]

would that intake work with my setup if i just relocated my battery and cruise control

This post has been edited by Etak28: Oct 10, 2008 - 12:33 AM

[6strngs]

would that intake work with my setup if i just relocated my battery and cruise control

I was using it with a CT26 turbo, but I was expecting it to also work with the T3/T4. so, I'm not 100% sure since I never test fitted it, but i'm fairly sure. If it didn't fit, all that would need to be done would be to cut a little length off it and it would fit. it wouldn't have a beaded end anymore, but that's not necessary for the intake since the pipe is under a vacuum, not a pressure like the intercooler piping. heck, I didn't even have beaded ends on my intercooler piping!