My Progress going bad..., thing going wrong now!!!!! Options

[RUNNIN-LOW]

This is what I have done so far. I still have to fab up a downpipe and figure out how to make a IC piping for the snailshell to the intercooler.


ok first picture if you look closely you can see i had to trim my fan haha & im worried cause i only have like about half a inch from the clutch clyinder bleeder valve..

showing off the heat shield i had to fab up to make work

showing how i did the oil feed line and the turbo..i love it!!

third gen block fitting

the real street tunning waste gate and the turbo adapter that muggs let me borrow..it looks good i think

the other side of the wastegate and if you look really close you can see i had to trim the heat shield for it to work

more pictures of the getto rigged fan and how close the turbo sits to the fan and raditor





and my bueaty with the front mount infront haha

ooh muggs i sand blasted the downpipe and painted it with high temp paint over all it looks good but i wont be able to use it cause it doesnt match up with my exhaust so the car will be taken to map performance for a new downpipe..

This post has been edited by RUNNIN-LOW: Oct 27, 2008 - 7:53 AM

[RUNNIN-LOW]

alright started the car up and it fired her up..when i rev her up to 3k rpm it starts to backfire like crazy and the car stalls out. fire starts to shoot out of the wastegate. i figured out that it was the real street wastegate, i didnt have the fire ring that came with it. went and got that and installed it. now the car runs fine but in the morning i let the car warm up and i start to drive her. the car kinda stalls out check engine light flashes, then once i step on the clutch the car goes back to normal this happens about 3 times then the car runs fine. anyone have any clue???ooh yeah once all that happen my airbag light came on but i think i just have to reset it.