7A-FTE made in Germany |
7A-FTE made in Germany |
Dec 27, 2008 - 5:10 AM |
|
Enthusiast Joined Dec 9, '05 From Germany Currently Offline Reputation: 0 (0%) |
Hi, after over a year of gathering parts my Celica finally is in the garage and gets her custom header, exhaust and some other stuff.
Yesterday we fitted the big Evo9 intercooler, i had to get the ST205 crash bar because the stock one is to tight, intercooler piping was done too and i'm very happy with it. I will use the stock ST205 air filter box, since there is not much space between the filter box and the engine, the IC piping is a little bit tricky but it looks like we found a good route. The header will be done in the next days. Short list of parts i'm using: - Garrett T25 Turbo from a CA18DET - Mitsubishi EVO 9 Intercooler - E-manage Ultimate - Innovate LC-1 Wideband - ST202 3S-GE Injectors (372ccm) - ST205 Fuel Pump - Bosch Blow-Off from a Audi S3 - Custom Header and 3" Exhaust - dozens of other small parts |
Jan 4, 2009 - 9:05 AM |
|
Enthusiast Joined Dec 9, '05 From Germany Currently Offline Reputation: 0 (0%) |
Header is completed and the rest of the exhaust will be done this week.
|
Jan 5, 2009 - 12:18 AM |
|
Enthusiast Joined Mar 8, '04 From Newport, RI Currently Offline Reputation: 63 (99%) |
do you plan on not using the fans anymore ? it looks like it's going to be a tight fit.... I would of suggested putting them or at least one on the opposite side of the radiator but with that IC and the big horn there, might not be much room there either. also, get a new radiator. Yours looks about 14 years old and with the excessive heat from that set-up you'll kill that one sooer than you think. -------------------- |
Lo-Fi Version | Time is now: August 19th, 2024 - 6:04 AM |