Why MR2 Power FC do not fit exactly in the ST205?? |
Why MR2 Power FC do not fit exactly in the ST205?? |
Jan 11, 2009 - 11:30 AM |
|
Enthusiast Joined Apr 14, '08 From Paraguay Currently Offline Reputation: 0 (0%) |
Hi guys..
Looking in the web for the ST205 3SGTE Gen 3 Power FC Plug n' Play i found this product on Berk Technology, for the MR2 3SGTE Gen 3.. http://www.berktechnology.com/shop/product...35&P_ID=480 so.. there says: "Re-wiring required for use on the 94-up Celica ST205 Alltrac".. my question is WHY???.. it's supposed they are same OEM Ecu, engine, etc, right???.. In case it's necessary a re-wiring, what should be changed and how???... Thanks in advance.. Best regards.. Miguel.. -------------------- No se sabe de lo que se es capaz hasta que se intenta... ;) |
Jan 11, 2009 - 9:02 PM |
|
Enthusiast Joined Dec 15, '02 From Tasmania(Australia) Currently Offline Reputation: 0 (0%) |
Im running an MR2 Power FC Pro ecu in my 205, no mods needed, straight plug in.
In some cases the ecu/wireing loom is a little bit different in some cars depending on destination. EG. to run a jdm ecu in an adm car you need to swap a couple of pins over, because their output point on the ecu is in a different spot. Not hard if you have the correct wireing diagrams. As for the gen3 mr2/st205 there was no australian delivered turbo sw20 mr2's, but obviously there was 205's and like i said im using the mr2 pfc pro in mine with no mods. I say go for it. This post has been edited by Cuts_the_Pilot: Jan 11, 2009 - 9:05 PM -------------------- ST205 Group A Rallye GT-Four, #61 of 77............600hp GT3582r
GRX133 Toyota Mark X 350s |
Lo-Fi Version | Time is now: November 23rd, 2024 - 8:30 PM |