Changing my clutch - ST202 Options

[korban]

Changed my clutch a few months back, thought I'd post some pics of the carnage.

After removing the wheels, axles, North-South cross member, exhaust and 3 engine mounts, I was ready to remove the gearbox and lower it using some ratchet tie-downs and an engine crane.



You can see where I had chains on the engine, as my first method was to support the engine with the crane and lower the gear box with the trolley jack.
This method was not working well so I swapped, and supported the engine with the jack and lowered the box with the crane.



This gave me access to the pressure plate (which I replaced along with the release bearing and clutch of course). The kit of all three parts was cheaper from MrT than the clutch by itself.



One hell of a job, wouldn't recommend it to anyone that hadn't been involved in a clutch change before, a Celica one would be even better.
But saved myself some decent cash, so rewarded myself with a new 6 drawer ball bearing slide tool chest (as finding my tools was a PITA while doing the job). I also bought a 30mm axle socket, a set of offset ring wrenches and a set of pry bars. Borrowed tools were: a 'sludge gun' for refilling the gearbox, and a clutch alignment tool (which the rounded end of a broom handle would have been perfect for anyways).

[3WayStunna]

Good looking job bro....man that looks like a hell of a job....