6G Celicas Forums

Welcome Guest ( Log In | Register )

> Warm start issues, Car has hard time starting when engine is warm
post Mar 2, 2009 - 3:55 AM
+Quote Post
John93GT

Enthusiast

Joined Dec 25, '05
From Gainesville, FL
Currently Offline

Reputation: 0 (0%)




Car: 94 GT Manual 300K miles

Situation: When starting the car with the engine warm, the engine will turn over and over and over without starting. If I give the car a little gas while turning over, the car will start up, and then have a rough idle for a few seconds and be fine.

The odd thing is, if I start the car using this method, turn it off, then try and start the car again immediately it will start up with no issues. If I end up leaving the car for 15-30 minutes (I've timed it) then it doesn't want to start. I don't even know where to begin with this one.... Any suggestions?
 
Start new topic
Replies
post Mar 14, 2009 - 2:05 AM
+Quote Post
John93GT

Enthusiast

Joined Dec 25, '05
From Gainesville, FL
Currently Offline

Reputation: 0 (0%)




QUOTE (Remy @ Mar 2, 2009 - 12:57 PM) *
Get your battery checked and make sure your terminals aren't corroded.


The terminals and battery are fine. The thing is that the car turns over and will keep going until I press the gas pedal... then it starts up with a crappy idle.

QUOTE (Bitter @ Mar 2, 2009 - 9:31 PM) *
you getting fuel into the engine when it won't restart?


In all honesty, based on my limited knowledge, I would imagine it to be something fuel related seeing as when I press the pedal it starts... but I don't know. I didn't think that pressing the pedal on newer cars made a difference when the car was off. confused.gif

QUOTE (stephen_lee @ Mar 5, 2009 - 12:56 AM) *
do you have any codes?
btw, not every code lights the CEL


I have no clue... every single time I have tried to pull the codes using the paperclip trick, the CEL comes on and stays on. No flashing whatsoever... Maybe I am doing it wrong.

post Mar 14, 2009 - 12:43 PM
+Quote Post
stephen_lee



Enthusiast
*****
Joined Mar 22, '07
From Houston, TX
Currently Offline

Reputation: 4 (100%)




QUOTE (John93GT @ Mar 14, 2009 - 2:05 AM) *
QUOTE (stephen_lee @ Mar 5, 2009 - 12:56 AM) *
do you have any codes?
btw, not every code lights the CEL


I have no clue... every single time I have tried to pull the codes using the paperclip trick, the CEL comes on and stays on. No flashing whatsoever... Maybe I am doing it wrong.




E1 & TE1?
should be the center and bottom towards you


DIAGNOSTICS
x_x__X__x_x_x
x_x_____x_*_x
x_x__X__*_x_x



X and x = pins
* = pins you should short out to get the codes
_ of course is just blank space (we cant add more than one space in succession kindasad.gif )

This post has been edited by stephen_lee: Mar 14, 2009 - 12:47 PM


--------------------
QUOTE
"And, as always, your friendship, help, and dedication to the advancement of Texas Celica dominance is GREATLY appreciated. Thanks bro." -DEATH

1994 GT: V6 swap, 5speed E53 W/ LSD, All Power, now RED
1995 ST: SOLD @273k miles, Auto, all power, CarPC, White
1994 ST: Totaled, 5spd, all power, Red RIP 07/09/09 @ 241,810
1994 Lexus LS400: This is my new DD

Posts in this topic


Reply to this topicStart new topic
9 User(s) are reading this topic (9 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: February 12th, 2025 - 10:01 PM