 Timing belt shreddng |
 Apr 5, 2009 - 7:07 PM
|
 
|
 Enthusiast  Joined Jan 25, '08 From Topeka, KS Currently Offline Reputation: 0 (0%)  |
Hello,
I just put a new timing belt on because my last one ( a few months old) shredded. It now looks like my new one is doing the same. It looks like it is rubbing against the block and badly against pump. I made sure to try and center it on the pully's when I installed both of them. Any ideas why this is happening? Thanks -------------------- 1st car- 1994 Celica GT 2.2L 5s-fe SOLD
2nd car- 1995 Celica ST 2.0L 3s-gte SOLD Current car- 1996 Z28 Camaro 5.7L LT1 |
 |
Replies
|
Apr 9, 2009 - 8:15 PM
|
|
 Enthusiast Joined Mar 31, '04 From Summerville, SC Currently Offline Reputation: 5 (100%) |
I've seen this happen once before on a 3SGTE. There is a thick washer behind the tensioner pulley (between the pulley and the block) that was misplaced. Without it there, the belt kept pulling in towards the engine and shredding itself.
-Doc -------------------- -Dr Tweak, 6GC's resident engine swap wiring expert extraordinaire Click here to see my swaps drtweak@phoenixtuning.com |
Posts in this topic
turboman23 Timing belt shreddng Apr 5, 2009 - 7:07 PM
Cuts_the_Pilot tentioner on correct? if its not sitting flush wit... Apr 5, 2009 - 9:33 PM
turboman23 QUOTE (Cuts_the_Pilot @ Apr 5, 2009 - 9... Apr 7, 2009 - 5:52 PM bmj67 there is an alignment pin for the tensioner if you... Apr 7, 2009 - 6:01 PM Cuts_the_Pilot yeah it bolts to the block but if your not careful... Apr 7, 2009 - 6:27 PM azian_advanced you may have warped pulleys (from age and high mil... Apr 8, 2009 - 12:25 AM presure2 QUOTE (azian_advanced @ Apr 8, 2009 - 12... Apr 9, 2009 - 9:20 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: December 4th, 2024 - 1:21 AM |