3sge Beams into 98 GT Options

[2bcelica]

I've seen a few post with some details for this swap, but not specific enough to give me a direct answer.

I know a few have successfully done this swap and now its my turn to ask for help.

I have a 98 Manual GT and wanted to know if there are any parts or anything I need to look out for when doing this swap.

I will be picking up this Beams next Monday. The harness, ecu, air flow meter, header, shifter, fuel pump, axles, and tranny are included in this set.

Does the harness need to be rewired to work or is it just plug and play?

Any info is greatly appreciated. Thanks

[Outsider]

I did my harness (past avionics tech experience).
It did throw me for a loop though. After everything was installed, It would not start. I traced it back to a non-existant but required jumper under the fuse box in the engine bay. It was something I missed when doing my wiring. If I remember corectly, I only had to cut about 4 or 5 wires and lengthen them. Mechanically, parts will bolt into place.

[2bcelica]

I did my harness (past avionics tech experience).
It did throw me for a loop though. After everything was installed, It would not start. I traced it back to a non-existant but required jumper under the fuse box in the engine bay. It was something I missed when doing my wiring. If I remember corectly, I only had to cut about 4 or 5 wires and lengthen them. Mechanically, parts will bolt into place.

i haven't start work on the beams yet cause of other obligations, but I was wondering and I'm sure i'll find out when I do work on it --- are all the plugs and wiring scheme the same? since you mentioned that you only had to lengthen only about 4-5 wires. I have a copy of the beams wiring diagram and 5sfe diagram, but haven't looked into it yet, since i know i'm going to forget unless I'm doing it while looking at the diagram at the same time.