Basic how to/walk through on Removing the Transmisson, reference thread for people Options

[808celica]

gonna set up this thread before i foget. I'll be pulling the trans and everything else with it so people car use this, or not, as reference to removing axles, starter, and transmission.

not gonna be a perfect thread but it should do.


-unhook battery

-remove cruise control when applicable

-remove starter


-unhook shifter cables


-remove slave from trans

-drain tranny

-remove axles










remove speed sensor
-----its behind the shifter cables just unhook it like the back up light

-remove backup light sensor


-remove center cross member


-remove front mount



-remove rear mount



-support engine, unbolt trans mount



-support trans



-lowering trans




-remove Pressure plate, disk, bearing








-remove fork (cuz im replacing mines) it just pulls right out



Installation is reverse sorry i didnt get pics i was doing this part by myself

This post has been edited by 808celica: Jun 17, 2010 - 9:48 PM

[808celica]

Oh i read your question right I doubt the pressure plate bolts are easy to get to with the trans oh say about 4in. from the engine. There is just no room to get at it safely IMO. My car is sitting about 4ft. in the air in my garage on jack just to let you know