Basic how to/walk through on Removing the Transmisson, reference thread for people Options

[808celica]

gonna set up this thread before i foget. I'll be pulling the trans and everything else with it so people car use this, or not, as reference to removing axles, starter, and transmission.

not gonna be a perfect thread but it should do.


-unhook battery

-remove cruise control when applicable

-remove starter


-unhook shifter cables


-remove slave from trans

-drain tranny

-remove axles










remove speed sensor
-----its behind the shifter cables just unhook it like the back up light

-remove backup light sensor


-remove center cross member


-remove front mount



-remove rear mount



-support engine, unbolt trans mount



-support trans



-lowering trans




-remove Pressure plate, disk, bearing








-remove fork (cuz im replacing mines) it just pulls right out



Installation is reverse sorry i didnt get pics i was doing this part by myself

This post has been edited by 808celica: Jun 17, 2010 - 9:48 PM

[808celica]

dONE!! putting the motor was a PITA!!! and the rear mount was a bitch too. pics

have a little pridicament though friggin leaking gear oil right where my driver's axle goes in the trans. i forget that name of that seal well back to toyota again i guess

found the seal its listed as oil seal for differential side bearing retainer #90311-35019


Driver's axle how to write up from someone else

This post has been edited by 808celica: Jul 3, 2009 - 7:20 PM