WTB: Red Injen 3" Coupling, minimum 4" long - 6" would be ideal Options

[DEATH]

I've still been having a few problems keeping IC piping clamped at high boost levels so I took this 6" long injen coupling I've had laying around for years and used it to hit the main problem area which was the Turbo outlet/hot pipe connection. I slipped it over the 5 ply expensive coupling I had on there and clamped it in 3 places:


So this has fixed that problem rather nicely and I previously fixed all other connections in a similar fashion with the exception of the one on the cold pipe immediately to the right in the pics above. The good 5 ply coupling that I have there is simply too short [3"] to clamp in anymore than 2 spots and so now it's the one that blows off.

So here is what I'm looking for:
I need a Injen brand Red coupling with a 3" diameter [2.75" minimum inside diameter] and a minimum of 4" long but ideally a 6" long coupling would do the trick quite nicely. This will allow me enough room to slip it over the high dollar coupling I have on there and then apply 2 clamps to each side [one for the injen the other over the injen to clamp the expensive coupling underneath].
It would totally be cake if it had the Injen Logo on it like the one shown as these are the first thing you see through the hood vent before I pop the hood and obviously appearance means alot to me.

If anyone has one laying around or is willing to trade out their existing coupling for another brand +$$$ please hit me up.

This post has been edited by DEATH: Jun 27, 2009 - 7:04 PM

[pittfirefighter]

think of it as a condom over his 5ply coupler... its a just in case bad stuff happens