Climate control wiring Options

[Cavegod]

Hi all i am curently installing cauto climate control in to a non climate control car so thats climate control out of a 1994 jdm Gen6 Celica st202 and installing it into a 1997 uk Gen6 gt st202.

does anybody know where to get a wiring diagram for the auto climate control system as i can only find one for a Gen5 st182 celica.

heres hoping

Pete

[Cavegod]

Ok BSD here you go

here is my jdm compressor with the uk wiring plug and yes i am missing the 4th wire yellow/black it conects to a cylinder on the back of the compressor near the exhaust and then earths.



here is a pic of my throttle position sensor am i missing a wire?



ok inside the car now the big multiblock connector on the top of the evap housing

JDM



UK minus the red/yellow (pressure switch) and blue/yellow (compressor relay earth)



heres both the uk and jdm relay side by side both identical even part no.s



this is the pink/blue wire



it goes to here which i think is one of the three vertical connectors below the radio



as you can see that is where it stops



right that just leaves the multi plug below the evap

this is the climate control side female plug



uk male side



jdm male side



jdm and uk side by side 'jdm plugged in'



so as you can see i have 2 wires not connected the yellow/black (compressor) and the blue/ yellow which is 12v live and according to th ewiring diagram goes to the ecu 'ATS'

so if i connect the yellow/black to the compressor where does the throttle position sensor wire connect to as i only have the 12v blue/yellow not connected?