New member. Celica SS-III BEAMS Options

[Ronan]

Howdy!

I cant seem to find an Introduction section so i'll just post it here..

My name is Ronan, im from Limerick in Ireland and i drive a '98 Celica SS-III.

'98 Toyota Celica SS-III
2.0 Yamaha BEAMS
Super Strut Suspension
Kakimoto Cat Back
Drilled and Grooved front Disks
Induction Kit
Alloy Oil Cap
17" BSA Alloys 215cm but have a set of 16" Enkei RP-F1s ordered to improve handling. 6.2kg per wheel!
Pivot Rev Clock (might remove it, although it looks well at night)
Fog Light fitted under Rear Bumper (legal requirement)
Standard front and rear strut braces. Rear has a Black cover witch looks sweet
Red Sparco Gear Knob

Mods to follow for now:
Apexi Air intake plus some sort of cold air feed
buddy Club race Spc condensor
NGKR Platinum Plugs
Upgraded Plug Leads
TRD 1.3bar Rad Cap
Stiffer Suspension (type undecided)
Better break Pads
Stainless Decat

Car was imported from Japan in 07, Spent a year in England then i went over and brought it back. Also i removed the Blitz stickers.









I previously had a '98 Toyota Levin BZR (4AGE Blacktop 1.6 20 valve, also had Super Strut suspension) but sold it as i ran out of things to do to it





This post has been edited by Ronan: Jun 3, 2008 - 12:45 PM

[BonzaiCelica]

hey sorry for the spoiler. So the left passenger seat is too tall, you said it hits the roof. How much lighter are those seats than stock?

Hey Rusty, getting 169 whp from 3sge beams redtop is where it should be at.

An integra type r Jap spec gets the same wheel horspower. of course you have to remember, fwd drivetrain.

I thought you were selling your car??

This post has been edited by BonzaiCelica: Sep 19, 2009 - 6:56 PM