My Project Headlight... Projectors+Angel Eyes+LED, Done with the project!! Thx Rayme 4 Clear lenses Options

[vincent_doggy]

Since my JDM Projectors was smashed, I need some quick and inexpensive way to rebuild my 6GC

But since Rayme out of stock of Clear Lenses, if anybody could part the clear lense and send to me ASAP for me to finish this project and my car, that would be much appreciated

Paypal Ready, or can trade with my stuff, Brand new JDM Tails, Curren Tails, Door Sills, Armrest combo, etc...






This post has been edited by vincent_doggy: Sep 9, 2008 - 11:13 PM

[snakeloa]

Hello together, hello vince.

Today i started to retrofit some headlights.
I got the glass off very easily. 120°C in a steam oven 5 Minutes and then just slightly use a knife or a palet knife or so.


Then i took the headlights apart. No problem.

I then started to dremel out the inner circle of the refelctor.
see picture:


then i tried to get it a little square...



But now before i go further i have got a few questions.

1) How much should the projector itself look out on the backside of the reflector?




2) At the projector itself is there a left and a right one? They both look the same.


3) At the projector there is this metal plate which covers a part of the light. You know. But when the projector gets attached will this metal plate be on the upper site or on the bottom of the Projector? I gues on the upper site like this:


Please answer to all questions. Thank you.

Joerg

This post has been edited by snakeloa: Sep 29, 2009 - 6:42 PM