7A-FTE made in Germany |
7A-FTE made in Germany |
Dec 27, 2008 - 5:10 AM |
|
Enthusiast Joined Dec 9, '05 From Germany Currently Offline Reputation: 0 (0%) |
Hi, after over a year of gathering parts my Celica finally is in the garage and gets her custom header, exhaust and some other stuff.
Yesterday we fitted the big Evo9 intercooler, i had to get the ST205 crash bar because the stock one is to tight, intercooler piping was done too and i'm very happy with it. I will use the stock ST205 air filter box, since there is not much space between the filter box and the engine, the IC piping is a little bit tricky but it looks like we found a good route. The header will be done in the next days. Short list of parts i'm using: - Garrett T25 Turbo from a CA18DET - Mitsubishi EVO 9 Intercooler - E-manage Ultimate - Innovate LC-1 Wideband - ST202 3S-GE Injectors (372ccm) - ST205 Fuel Pump - Bosch Blow-Off from a Audi S3 - Custom Header and 3" Exhaust - dozens of other small parts |
Nov 14, 2009 - 2:33 PM |
|
Enthusiast Joined Jun 18, '09 From Orlando Currently Offline Reputation: 8 (100%) |
Alright. Well, I guess it is money well spent. I know you did two turbo setups, and a tune for each I'm guessing, so do you think you would have spent less than a 3S-GTE swap if you had done only a single setup and single tune? Without any mods not absolutely necessary to turbo'ing, of course.
This post has been edited by SwissFerdi: Nov 14, 2009 - 2:33 PM -------------------- '97 ST \ Eibach \ KYB \ Kenwood \ Alpine \ Cusco \ OEM+ [sold 10/18]
'93 MX-5 LE |
Lo-Fi Version | Time is now: August 2nd, 2024 - 4:53 PM |