wtb pwr stering (thing) and other (things) Options

[Dragondog]

on my pwr ster pump thers a cap that has two lines that connect to it the cap busted so now thoes two lines just hang there......i dont know what it is r whats used for.....i went to az to see if they had and they dont know whut it is........also i have a senser on my block under the intake that i need to replace........and also a vaccum part 2 lines run to it they r for the charcle canister it screws in on this coolent housing next 2 2 other sensors one being a temp sensor the houseing is next to the distributor....thx

[Dragondog]

if the the pwr stering valve is not nessisary then ill pass on that unless i can get it from you for a low price.........the knock sensor i dont know how much they run so i dont know what to base it off of......my hopes were to get these parts under 50$....or all three for 50$....but let me know whut you can do...your knock sensor is it original? chiped? cracked? brittle?

This post has been edited by Dragondog: Dec 7, 2009 - 8:47 PM

[pittfirefighter]

if the the pwr stering valve is not nessisary then ill pass on that unless i can get it from you for a low price.........the knock sensor i dont know how much they run so i dont know what to base it off of......my hopes were to get these parts under 50$....or all three for 50$....but let me know whut you can do...your knock sensor is it original? chiped? cracked? brittle?

i don't use the vacuum assist on my turbo car so i can sell you that for cheap... i can do knock alone for $40 or both for $50... knock runs around $150 new... mine is stock in working condition... they are either working or not... they don't go bad over time... not brittle either..