6G Celicas Forums

Welcome Guest ( Log In | Register )

> ground control install i made a bubu.
post Mar 3, 2010 - 2:07 PM
+Quote Post
terbear4god4life



Enthusiast
****
Joined Oct 10, '08
From sweet home, OR
Currently Offline

Reputation: 3 (100%)




on the rear installing ground controls did you guys have conned top hats?

i installed mine and in the front slammed its on the wheels but on the rear its still got good inch and a half gap??

theirs a rubber piece with a coupler is the spring supposed too slide around that?? or is the cone supposed to go inside it??



help! frown.gif frown.gif


--------------------
"she can polish my strut bar anytime As long as her blow-off valve's in good order"
 
Start new topic
Replies
post Mar 3, 2010 - 2:21 PM
+Quote Post
terbear4god4life



Enthusiast
****
Joined Oct 10, '08
From sweet home, OR
Currently Offline

Reputation: 3 (100%)




QUOTE (95CelicaST @ Mar 4, 2010 - 10:13 AM) *
The coned top hat is supposed to sit on top of the coil, with grease in between.

What is this rubber piece?

Post up a picture and I'll tell you what goes where.



on top of the rear theirs a rubber piece held on by a metal coupler was i supposed to take off the metal coupler(instead of tearing off the rubber of it?) than put the coilover around were the metal coupler was?

This post has been edited by terbear4god4life: Mar 3, 2010 - 2:22 PM


--------------------
"she can polish my strut bar anytime As long as her blow-off valve's in good order"

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: November 27th, 2024 - 5:47 AM