Throwing o2 code Question, Spark Plug Non Fouler Options

[6G96GT]

Welp, been out for quite some time but I am back to ask a question (hopefully Bitter will read this). I have two 02 sensors in my afternmarket header in the same location, one about 2" above the other. Why? I have no clue and yes it sounds stupid and it may even appear that I don't know what I am talking about but please beleive me...the header's 4 to 1 pipe (the 1 pipe part) has both o2 sensors in it and there is no cat or pre cat or anything at all.

So...the non fouler spark plug kit, will it work to put it in bank 2 ? I am throwing a code and says o2 bank 1 or 2 and I replaced bank 1 a couple months ago with an OEM one.

Is the non spark plug fouler kit a direct screw in fixer? I have no 02 in my cat at all. I even considered re-wiring the second o2 to reach my cat and add a bung and wld it right into it.

Help please?

[cyberblader1130]

Welp, been out for quite some time but I am back to ask a question (hopefully Bitter will read this). I have two 02 sensors in my afternmarket header in the same location, one about 2" above the other. Why? I have no clue and yes it sounds stupid and it may even appear that I don't know what I am talking about but please beleive me...the header's 4 to 1 pipe (the 1 pipe part) has both o2 sensors in it and there is no cat or pre cat or anything at all.

So...the non fouler spark plug kit, will it work to put it in bank 2 ? I am throwing a code and says o2 bank 1 or 2 and I replaced bank 1 a couple months ago with an OEM one.

Is the non spark plug fouler kit a direct screw in fixer? I have no 02 in my cat at all. I even considered re-wiring the second o2 to reach my cat and add a bung and wld it right into it.

Help please?

I have 2 sensors in my headers as well, you could try cleaning them. Either with a sensor safe cleaner or heat it up with a propane torch till it turns red, dip it in water, then blow dry it with an air hose. Either way i would just recommend replacing it with an oem replacement. but you could try cleaning it before you replace it. Hope this helps. Which one did you replace, the threaded one or the one that requires nuts and a gasket?

This post has been edited by cyberblader1130: Mar 15, 2010 - 4:55 PM