engine problem after rebuild, wont start and run Options

[STCelica]

alright well here is the story. i bought a 97 celica vert for 150 bucks and the engine that was in it threw a rod. so needless to say it was no good. i pulled the engine and got another 2.2 out of a camary. i turned the crank, new rings, valve seals the whole 9. anyways i but the damn thing back in and tried to start her but she will not run. the motor is in time check in 4-5 times, i got spark, fuel, and cmpression is about 155-160 in each cylinder. ive tried replacing the crank sensor, tps, i put in a new injectors off another motor i had. each cylinder is getting fuel cause the plugs are wet. the only thing i havent checked yet is the fuel pressure, but i know its getting up there. the only thing the motor doesnt have now is the egr and all the hose that went along with it. all my grounds are hooked up and ive even added a few. i just need some advice on what this could be, i am stumped. thanks in advance.

[Bitter]

thats weird that you'd have compression then, if the timing was off enough for it to not start...oh. i know why. duh! the spark/fuel are timed off the distributor which runs off the exhaust cam which was not timed to the crank/intake. so i bet fuel/spark was happening after or before the intake valves were open.