![]() |
![]() |
![]() |
|
Enthusiast Joined Apr 22, '10 From ohio Currently Offline Reputation: 0 (0%) ![]() |
ok so i took my old motor and tranny out.
and we were getting ready to put the new one in and we noticed that the third clip to the ecu from wiring is gone and that the maf clip isnt their does anyone kno were i can get some or have any advice or would take to give their opion on like a neptune stand alone ecu? ![]() Slim |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Aug 31, '02 From Philadelphia, PA Currently Offline Reputation: 8 (100%) ![]() |
A plug from a 4age fwd corolla series should work. You should go Megasquirt. They support dual VR sensors now for Toyota engines. When did this happen? -------------------- 15PSI - 30MPG - Megasquirt Tuned
|
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Apr 18, '05 From Lincoln, Ar Currently Offline Reputation: 7 (100%) ![]() |
A plug from a 4age fwd corolla series should work. You should go Megasquirt. They support dual VR sensors now for Toyota engines. When did this happen? When you build a 2nd VR Conditioner and run The megaSpark/n/Extra Firmware. They even have dual table switching now for hot days and cold days. So you can tune it for certain temps of the year and switch back and forth without re-programming. I have my MS2 V3.0 already solder and set. Just waiting to install and tune. This post has been edited by soulshadow: May 7, 2010 - 8:12 AM |
![]() ![]() |
Lo-Fi Version | Time is now: February 21st, 2025 - 9:35 AM |