Basic how to/walk through on Removing the Transmisson, reference thread for people Options

[808celica]

gonna set up this thread before i foget. I'll be pulling the trans and everything else with it so people car use this, or not, as reference to removing axles, starter, and transmission.

not gonna be a perfect thread but it should do.


-unhook battery

-remove cruise control when applicable

-remove starter


-unhook shifter cables


-remove slave from trans

-drain tranny

-remove axles










remove speed sensor
-----its behind the shifter cables just unhook it like the back up light

-remove backup light sensor


-remove center cross member


-remove front mount



-remove rear mount



-support engine, unbolt trans mount



-support trans



-lowering trans




-remove Pressure plate, disk, bearing








-remove fork (cuz im replacing mines) it just pulls right out



Installation is reverse sorry i didnt get pics i was doing this part by myself

This post has been edited by 808celica: Jun 17, 2010 - 9:48 PM

[lagos]

VERY COOL!
btw, you dont need to remove your hubs or your tie rods. you can just unbolt the top two suspension bolts, and swing the whole assembly out of the way.

[KAOS]

VERY COOL!
btw, you dont need to remove your hubs or your tie rods. you can just unbolt the top two suspension bolts, and swing the whole assembly out of the way.

What top two bolts are you referring to here? Would you happen to have pics to show us?

(I have to swap out a tranny right away here and want as much research under my belt as possible before I start... hence the "back from the dead" thread)