Blown 7A redemption, attemp #2 Options

[Cevax]

Haven't been here in a couple of years but some of you will remember by 7afte turbo project that was a complete failure. Swapped in a 7a and started the the turbo project and blew up in the highway a few days later.

On my first project I didn't do any of the work outside from some wiring. This time this is a true backyard build anyway my goal is 450 on race gas 380+ on pump. 7.4:1 compression with 25 pounds of boost

Anyway I wont update this a lot since its on other forums

Engine is Fully built, only stock part is the throttle body, wont go into details because non of you really care

Car does no run yet
Stuff missing

New exhaust manifold
Standalone EMS
New FMIC
















VIDEOS

Its loud in there especially when the fuel pump is on





This post has been edited by Cevax: Jun 23, 2010 - 9:59 PM

[Cevax]

The bigger throttle body wouldnt fit unless I grind down my intake manifold. Its not a stock manifold and I guess it doesnt support that tb. I am not going to bring a grinder to the manifold, so just put the stock back on until I can bring myself to spend the money, on a proper one. Its alot smaller but hopefully it doesnt hinder performance that much.

Been working on the motor for six months now, have changed my mind on things many times. Right now have a slightly modyfied td05h big16g, its ported so flows around 575-600 cfm. Currently mated to an older oem manifold from a different car until the new one arrives.

This post has been edited by Cevax: Jun 24, 2010 - 8:33 AM