Power Window Motor & Line Repair..help pls. Options

[rave2n]

Well as it states, somehow my passenger power window line got jammed up in the motor, and broke the motor and plastics...not to mention the line itself is pretty screwed.

I've done a search, but have found nothing useful on the motor replacement. Anyone done it before, few pointers would be nice, cause It certainly does not seem to be a easy install due to placement and complexity of where that metal line runs.

[GriffGirl]

It's actually pretty easy to do - you need to search for the regulator, which is the entire assembly and should include the motor as well.

To replace it, you'll need a 12mm (iirc) socket, a 10mm socket, and a short extension. You'll also need to be able to lower your window about halfway - when you remove the door panel, you'll see that there are service holes where you can access the bolts that bolt the window to the rail. First step is to unbolt the window, I believe there are 3 bolts (12mm). Then you will be able to pull the window up by hand and remove it - you *could* manage w/out removing the window all together, but trust me, it's WAY easier to just get it out of the way so you have room to work. With the curvature of the window, it will be near impossible to manipulate the regulator in such a way that you can get it out of the door.

After you've removed the window, you'll need to unbolt the regulator and motor from the door. If I remember correctly, there are 3 bolts holding it in - two are at the very bottom edge of the door, and one is toward the front of the door, about halfway up. (that's where the motor is). Unbolt the motor and regulator, and then grab a hold of the rail and rotate it sideways so that you can maneuver it out of the door through the larger hole in it. Oh, and there should be some electrical connectors to the motor - one is a two-wire connector that you'll see mounted on the door skin... maybe that's the only one, actually. I don't remember. But I think it is.

Installation is the opposite of removal. Depending on the position of the replacement regulator, you may need to "put the window up" so that you can access those bolts through the service holes so you can bolt your window back on.

Any questions, feel free to ask, and good luck! Check http://www.rockauto.com for a regulator, I believe they have them, and new, they're maybe in the $80-$90 range? Not sure...