Just a lil turtle- Playr's car, (the entire project) Options

[playr158]

Awhile ago Jeff told me to consolidate my crap so here goes

Spec:
1996 USDM ST


Stage 1:
-invader body kit, custom bumper scoop, Velox VX-6 18" wheels, Arospeed Coilovers, GT4 rear strut bar, several different exhausts, JDM tails, 5th gen power folding mirrors




Stage 2:
- supra front end conversion (only 75% completed at any given point)


all in all, it got the whole deal of under glow, interior neon, subs, amps, dual/single exhausts, CAI, SRI, TWM SSK, and most things under the sun you can do as a ricer.

now......that stuff comes to an end and the story starts over

Step 1: remove horrible front end


Step 2: remove motor (note you can see missing "sub" frame here



Step 3: power wash clean the empty bay


Step 4: Jack stands on 4 corners and remove suspension





Step 5: pointlessly tape up and start stripping






Step 6: black primer




Step 7: ditch the interior internals



Step 8: drive to jersey in overheating truck to get a bare clip (don't forget to remove excess)





Step 9: remove donor firewall



9b: remove my firewall


Step 10: replace with donor wall


Step 11: find Ultra super dooper mad JDM elephant tite Curren parts, drive Ghetto nascar van to get it


Step 12: install Ultra super dooper mad JDM elephant tite Curren parts




Step 14: ditch the sunroof its way too heavy


Step 15: ditch spare tire well, make more room under car smooth out floor board


Step 16: remove glass from doors (heavy, and you can't have windows up while racing)

Step 17: paint engine subframe hot pink because you can



Step 18:
Realize your garage sucks so put up ceiling: only partially finished, gotta get more and clean out the crap a lot more
(its a temp garage so we make do) car modification pictures will come soon



Step: 19 Carbon fiber license plate trim


more to come soon as I get more done

This post has been edited by playr158: Jun 3, 2009 - 9:56 AM

[playr158]

pretty sure the headlights were ziptied in

yea no.....


New stuff that I picked up last weekend
(these are all spares to the ones I already have)
RHD Brake master cylinder & booster
RHD Clutch master cylinder
RHD gas/brake/clutch pedles
RHD Dash/support/steering column
RHD K-frame/steering rack

The stuff thats new to me (1st sets)
ST205 AWD trans
ST205 driveshaft
ST205 Rear Differential/axles/cradle

Going to Europe for a bit, so I'll start work on the AWD stuff and more of the project when I get back, Pictures will come then.