Noise After Cams Upgrade Options

[fgvillegas]

i upgraded my cams yesterday to 272 duration and 9.3 lift for both intake and exhaust. i noticed that my engine became so noisy. it's like someone's working on a typewriter.

my mechanic said that it's natural because i used stock valve springs. my tappets, according to him, is also within specs so i don't need to worry.

after driving so long, i also noticed that my oil pressure is almost zero. my sensor connection is okay and when i rev the engine, the reading goes up also. again, according to my mechanic, it is natural for the oil pressure to go lower than usual when you upgrade cams and the reason why i am probably getting a very low reading is that my gauge may not be very accurate. btw, the brand of my gauge is autogage and my cams is Jun.

please enlighten me on this. i plan to go to the dyno shop on monday and i'm not sure if this already okay.

thanks guys.

[Rusty]

I'd get it fixed asap

from the 3S-GE repair manual

reference: page 36 or book ref page ENG - 22
your valve clearance (cold)
Intake:
0.15mm - 0.25mm (0.006in. - 0.010in.)
exhaust:
0.28mm - 0.38mm (0.011in. - 0.015in.)

also from page 40 or book ref page ENG - 26
has info (charts and formula) regarding replacing shims (sizes)




whats the idle like otherwise with the cams?

This post has been edited by Rusty: Sep 12, 2010 - 1:35 AM