Super Strut To Macpherson, Changing the suspension on a ST205 Options

[lmac34]

Hi All,

After Searching long and hard and finding no info i decided to go ahead and give it a go and i have done it.
It was a pain in the hole but it is finally completed and to be honest there is very little difference in handling.

I not 100% on what everyone calls the parts but i will do my best to get it correct.

Parts Needed:
Lower Front Arm of ST202,
ST202 Suspension,
ST202 Knuckle,
ST202 Tracking/Steering Rod, you will need more thread (an extra 1 to 1.5 inch) on the Rod to track the front wheels.
Big Break Disc KIT for ST202.
ABS Senor of ST202,


AntiRoll Linkage around 1 or 1.5 inch i can not remember right now. (i can remember it was from a Nissan)
Wheel Bearings,
Front Prothane Urethane Bushings,
New Ball joints to connect Lower Arm To Knuckle.


Attach the Dust shield from ST205 Knuckle to ST202 Knuckle. holes will not match up so new holes will be needed.

Take the Hub off the ST205 knuckle and attach it to the Knuckle of the ST202 this way there should be no
problem connecting the drive shaft (add new wheel bearing etc).

Add the new Prothane Urethane Bushings to the Front Arm and connect to car. (help get back some handling) optional you can use the standard ones if you want

Add new ball joints connect Knuckle to LowerArm.

Connect the Suspension to Knuckle. I added Koni adjustable inserts to improve handling and ride quality and they where cheaper than coilovers.
Coilovers will come later

Attach new Big Breaks, (i got K Sport 6 spot breaks for the ST202) if you want you can try and attach the standard ST205 Breaks but i don't know how safe that would be.

and that should be that.

In the End it is possible and it is now done, so far running like a dream.
It dose cost a bit at first but should be better for you in the long run, parts are cheaper and easer got.
There is very little difference in handling, there is a small amount of body roll on cornering probably dew to damper setting on suspension,
And a little shaky at high speed i would say it is dew to the standard anti roll bars with the make fit anti roll linkages. i will try upgrading the anti roll bars with thicker ST202 ones later in the Year.

Well thats that, any problems or questions PM me.

Regards,
Lmac34

[Edophus]

you will need to upgrade the front antiroll bar as the design of superstrut has better roll resistance, the st202 superstrut antiroll bars are pencil thin because it simply doesn't need a big anti roll bar.