![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() Joined Dec 9, '05 From Germany Currently Offline Reputation: 0 (0%) ![]() |
Hi, after over a year of gathering parts my Celica finally is in the garage and gets her custom header, exhaust and some other stuff.
Yesterday we fitted the big Evo9 intercooler, i had to get the ST205 crash bar because the stock one is to tight, intercooler piping was done too and i'm very happy with it. I will use the stock ST205 air filter box, since there is not much space between the filter box and the engine, the IC piping is a little bit tricky but it looks like we found a good route. ![]() ![]() ![]() ![]() The header will be done in the next days. ![]() Short list of parts i'm using: - Garrett T25 Turbo from a CA18DET - Mitsubishi EVO 9 Intercooler - E-manage Ultimate - Innovate LC-1 Wideband - ST202 3S-GE Injectors (372ccm) - ST205 Fuel Pump - Bosch Blow-Off from a Audi S3 - Custom Header and 3" Exhaust - dozens of other small parts ![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() Joined Dec 9, '05 From Germany Currently Offline Reputation: 0 (0%) ![]() |
After taking the old engine apart i found out that the bearing wasn't the cause of the thrown rod, it looks like the spark plug overheatet extremely, the electrode began to glow and i got the worst of it all... pre-ignition. I'm not shure what caused the plug to overheat, i don't think it was a fuel problem but i will let the injectors get checked.
Here is a pic of the spark plug and some of the rest of the engine: ![]() ![]() ![]() ![]() The new block is getting machined this week and a new cylinderhead is allmost done, i just have to polish the combustion chambers and finish the ports. ![]() ![]() ![]() ![]() ![]() |
![]() ![]() |
Lo-Fi Version | Time is now: August 19th, 2024 - 4:01 AM |