 94-99 GT Front Wheel Bearing Measurements |
 Nov 19, 2010 - 4:00 PM
|
 
|
|
Enthusiast  Joined Feb 23, '05 From New York Currently Offline Reputation: 0 (0%)  |
has anyone ever measured the front wheel bearings? or can point me to a link with the specs? mm or inch is fine.
|
 |
Replies
|
Nov 22, 2010 - 11:49 AM
|
|
 Enthusiast Joined Nov 21, '05 From Tacoma, WA Currently Offline Reputation: 7 (100%) |
I have one out in my shop that I haven't gotten around to putting in. I'll go measure it and post results.
I wouldn't say that a bearing driven couldn't get it out but you would have to swing pretty hard to do it and would probably bend or break something. I just used my ball joint/ujoint press that I bought at harbor freight for $30. |
Posts in this topic
eazy2001x 94-99 GT Front Wheel Bearing Measurements Nov 19, 2010 - 4:00 PM
Culpable04 I need a new one, and will get it tomorrow, once I... Nov 19, 2010 - 6:28 PM 99GT To build a brake setup I'd assume for his kill... Nov 19, 2010 - 9:19 PM eazy2001x not quite.. its for a custom axle setup.. i think ... Nov 22, 2010 - 8:11 AM Culpable04 I have visitors so it'll take me a few days to... Nov 22, 2010 - 8:56 AM 96stgreendemon stupid question, but how do you go about changing ... Nov 22, 2010 - 9:18 AM eazy2001x you have to remove the whole spindle then have it ... Nov 22, 2010 - 9:36 AM 96stgreendemon hmm what about some kind of bearing driver/race? Nov 22, 2010 - 9:41 AM
eazy2001x I dont understand your question. Nov 22, 2010 - 10:10 AM RocketScott Timken 514002B
OD 74.00mm
ID 38.00mm
Outer Race T... Nov 22, 2010 - 11:59 AM eazy2001x your the man.. ill forward that info over to the b... Nov 22, 2010 - 12:46 PM eazy2001x Well it seems that Drive shaft shop cant make me a... Nov 23, 2010 - 10:00 AM Culpable04 that won't work, the bearing has to be pressed... Nov 23, 2010 - 9:03 PM RocketScott The inner races of the timkin bearings i bought co... Nov 24, 2010 - 12:40 PM eazy2001x yeah.. i am looking for a company who will make cu... Nov 24, 2010 - 12:55 PM Culpable04 there is enough room to bore the knuckle to take a... Nov 24, 2010 - 6:37 PM |
10 User(s) are reading this topic (10 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: February 20th, 2025 - 10:45 AM |