New alternator question |
New alternator question |
Feb 26, 2011 - 3:59 PM |
|
Enthusiast Joined Jun 30, '05 From Chattanooga, TN Currently Offline Reputation: 5 (100%) |
I installed a new alternator 170 amp. it seems to be working great. it drove to the gas station, but then for the first time in years my car wouldnt start and i had to roll start it today. ive got an optima yellow top battery.
I have upgraded the battery ground, but have not upgraded the alt to battery wire or the engine to chassis wire. I was testing out my alt and was cranking out music, my speakers pulled about 60 amps and the speakers started to get fuzzy and quiet, so i turned the volumn down and revved the engine out of instinct, and it went away before i could figure out what was going on. I know this is probably a stupid question, but is it possible i blew some charging fuse or something? voltage shows 14.5 when running and was showing 11.5 when it wouldnt start. Does the wire from the alt go straight to the battery, or does it split or get fused at any point? Happy to give any more info, i just dont know what else you may need to know. Thanks |
Feb 26, 2011 - 6:19 PM |
|
Enthusiast Joined Jun 30, '05 From Chattanooga, TN Currently Offline Reputation: 5 (100%) |
heres whats happened so far
started car fine and went to gas station went to leave and it wouldnt start so i pushed it down a hill and popped the clutch and it started went inside for a few hours installed 4ga fused wire from alt to battery started fine listened to music for a minute i turned the car off and it wouldnt start again The car is not clicking like they usually do, its just buzzing like the solenoid is opening, but the starter wont turn everything was fine until i installed the new alternator, and when its running the voltage is right where it should be. This post has been edited by Stu37363: Feb 26, 2011 - 6:20 PM |
Lo-Fi Version | Time is now: November 28th, 2024 - 1:26 AM |