Rough idle - smooths out when I drive (going insane) |
Rough idle - smooths out when I drive (going insane) |
Mar 1, 2011 - 7:02 PM |
|
Enthusiast Joined Feb 8, '08 From NJ Currently Offline Reputation: 0 (0%) |
I have never found a problem with an engine that I was unable to fix with some moderate thinking.. but with this 1.8L engine I have done the following:
Symptoms: Car starts VERY FAST. Click vroom. Perfect. Idles 1200 or so to warm up, then drops to what appears to be factory setting around 750 or so. In park, or neutral the engine is vibrating but you don't feel it as bad. The moment you put it in a gear, R or D the entire car shakes to pieces. Touch the gas, and with a load the problem is magically gone until the next stop light... it never stalls. I just failed emissions for HC.. (unburned fuel... which made me think ignition system) - plugs - cap - rotor - wires - coolant temp sensor - egr check - re-ground everything - iac clean / check - vacuum sensor check - replace all vacuum lines - checked for leaks anywhere - set base timing to factory specs - changed fluids - changed motor mounts - unplugged and plugged back in every sensor to no avail - put on an entirely different distributor - drained the gas tank and put in all new fuel .. The only thing I can think of that I did not try is replacing the ignition coil in the distributor, it could be bad.. but the likely hood of both the old and newer distributors coils both being bad is probably slim... I'm going insane. Now after messing with the TPS my idle wont go below 1,000 or so.. guess I put it back in the wrong position. Oh well, I'll figure that out later but is there anything I'm missing here? I've tried everything I searched google many times I can't even find anything else to check. fuel pressure? Any ideas.... This post has been edited by 97Supra: Mar 1, 2011 - 7:05 PM |
Mar 7, 2011 - 7:53 PM |
|
Enthusiast Joined Feb 8, '08 From NJ Currently Offline Reputation: 0 (0%) |
New header / had to have a shop cut it at the flex and make it fit the car, ebay sent me the wrong one.. haha 02 sensors are new/er and a new catalytic converter was just installed about a month ago at meineke.
I'm gonna take your advice and order a new pigtail plug for the alternator since wiggling it makes the car die.. obviously the plug is screwed, but the low voltage output from the alt.. I will go get a new alt. tomorrow morning and install it. if it helps I will be very glad.. this cars been through a lot! |
Mar 7, 2011 - 8:20 PM |
|
Enthusiast Joined Oct 24, '09 From Appleton, Wisconsin 54915 Currently Offline Reputation: 7 (100%) |
New header / had to have a shop cut it at the flex and make it fit the car, ebay sent me the wrong one.. haha 02 sensors are new/er and a new catalytic converter was just installed about a month ago at meineke. Yeah... You'll have that with the ebay header's. Wasn't the wrong one, they're all like that. No where near a perfect fit. I'm gonna take your advice and order a new pigtail plug for the alternator since wiggling it makes the car die.. obviously the plug is screwed, but the low voltage output from the alt.. I will go get a new alt. tomorrow morning and install it. if it helps I will be very glad.. this cars been through a lot! It seems like the only issue is that little bit of wiring. Don't get a new Alt. until after you change that wiring. No use in spending more money unless you are absolutely sure it's the Alt. Or if you would just prefer a new one. :-P |
Lo-Fi Version | Time is now: November 25th, 2024 - 4:31 AM |