Good 8" speakers for doors, After much debate, I have found a great set of 8's for doors Options

[DGolden32]

I looked everywhere, both in car audio and home audio sites/companies and have found what i believe to be the best set of 8\'s for the buck the will ACTUALLY fit with no modification. They are home theater speakers, so they are very efficient (50watts max rms, sensitivity 84dB @ 33hz) and can reach high enough to do well in a 2 OR 3 way setup. And its 4 ohm, which is a bit harder to find in home theater speakers. I went ahead and found what i think to be a good tweeter match too. I would put a HPF on the tweeter at around 4.5-5k if the included crossover gives too strong of a midrange.

8\" speaker/sub
http://www.parts-express.com/pe/showdetl.c...tnumber=299-098

Just put a set of these tweeters on the same wires and be done with it

http://cgi.ebay.com/JBL-P26T-POWER-SERIES-...#ht_1691wt_1059

This post has been edited by DGolden32: Mar 16, 2011 - 1:10 PM

[Culpable04]

I'm pretty sure it'll hit the notes, hopefully the absorving mat eliminates the rattles on the door, there are plenty of small metal parts inside the door that will resonate the vibration, that's where most of the issue was, I do have absorbing mat installed but I'm sure you've done your research, so I'll pay atention to how you do it and maybe I can later improve my system base on your findings.