Rough idle - smooths out when I drive (going insane) Options

[97Supra]

I have never found a problem with an engine that I was unable to fix with some moderate thinking.. but with this 1.8L engine I have done the following:

Symptoms:

Car starts VERY FAST. Click vroom. Perfect. Idles 1200 or so to warm up, then drops to what appears to be factory setting around 750 or so. In park, or neutral the engine is vibrating but you don't feel it as bad. The moment you put it in a gear, R or D the entire car shakes to pieces. Touch the gas, and with a load the problem is magically gone until the next stop light... it never stalls. I just failed emissions for HC.. (unburned fuel... which made me think ignition system)


- plugs
- cap
- rotor
- wires
- coolant temp sensor
- egr check
- re-ground everything
- iac clean / check
- vacuum sensor check
- replace all vacuum lines
- checked for leaks anywhere
- set base timing to factory specs
- changed fluids
- changed motor mounts
- unplugged and plugged back in every sensor to no avail
- put on an entirely different distributor
- drained the gas tank and put in all new fuel

.. The only thing I can think of that I did not try is replacing the ignition coil in the distributor, it could be bad.. but the likely hood of both the old and newer distributors coils both being bad is probably slim... I'm going insane.

Now after messing with the TPS my idle wont go below 1,000 or so.. guess I put it back in the wrong position. Oh well, I'll figure that out later but is there anything I'm missing here? I've tried everything I searched google many times I can't even find anything else to check.

fuel pressure? Any ideas....

This post has been edited by 97Supra: Mar 1, 2011 - 7:05 PM

[stephen_lee]

raise the idle with that resistor guys. the idle is a factory spec 650-700 rpm. i induced a vac leak before to raise the idle (pulled that vac line of the top of the TB, closest to the front of the engine) it raised the idle...then the ecu "learned" and dropped it back down to 650ish when i plugged the line back in it dropped to 400 or so... then eventually raised back up to 650-700.. that resistor seems a permanent fix. 1 month so far