 Transmission Leak :( |
 Apr 8, 2011 - 2:55 PM
|
 
|
|
Enthusiast  Joined Mar 26, '09 From Colorado Springs Currently Offline Reputation: 0 (0%)  |
I just put a new axle in my car about 4 days ago. This is the driver side and it is on the 7afe. I noticed that the day after I did this the transmission is leaking where the axle goes into it. Now the little metal dust cover got bent when I pulled the old axle out. Could the leak be this bent dust cover because that does not seem like it could be. Or is it possible that I messed up the seal in the transmission when I shoved the new axle in there? Just wondering on some expertise here before I go tearing into the car again because that was a little bit of work pulling that axle and I want to know what it could be before I do this. Any help is greatly appreciated. Thanks
 Raves |
 |
Replies
|
Apr 8, 2011 - 3:13 PM
|
|
|
Enthusiast Joined Mar 1, '11 From Morgantown, WV Currently Offline Reputation: 0 (0%) |
I doubt the bent dust cover can cause the leak. Its usually a good practive to replace the rubber seal and the snap ring when you put the axle back in. Atleast changing the seal should stop the leak.
|
Posts in this topic
Raves44 Transmission Leak :( Apr 8, 2011 - 2:55 PM
chacha or that you didn't push it in all the way. Apr 8, 2011 - 3:39 PM Spider77 Usually the seal gets damaged upon removal of the ... Apr 8, 2011 - 4:24 PM Raves44 Ok now next question. What type of seal is this. L... Apr 9, 2011 - 1:22 PM Spider77 pressing it in isnt all that hard...I know somewhe... Apr 9, 2011 - 2:37 PM
xrav22 QUOTE (Spider77 @ Apr 9, 2011 - 2:37... Apr 9, 2011 - 3:02 PM 808celica Its called the "Output shaft seal" no mo... Apr 10, 2011 - 4:38 AM presure2 dont take the dust shield off, it has a purpose.
i... Apr 10, 2011 - 10:13 AM |
5 User(s) are reading this topic (5 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: February 18th, 2025 - 7:28 PM |