Beams is in - but won't start Options

[S8S8]

I've just finished converting my Aussie ST204 to Beams power using an ST202 SS-II clip, but I can't get the engine to start.

The engine turns over, but won't fire. We're pretty sure the problem is the fuel pump, as there is no fuel pressure. The relay on the ECU is operating, so the issue seems to be somewhere between there and the fuel pump. It was working fine with my old 5SFE just last week, so I'm sure it must be a wiring issue rather than an issue with the pump itself.

There are issues with wiring to the new instrument cluster too. It's way off, with all to wrong lights coming on for the indicators and high beam etc. The dash lights don't work at all either.

I'm not so worried about the dash issue at this stage, but thought I'd mention it on the off chance it could be connected with the non-starting issue.

Any assistance would be greatly appreciated.

[Rusty]

Check your wiring connections:
- make sure each wire/loom has somewhere to go
- make sure they're plugged in properly - not half plugged in

work you way back from the sparkplugs to the coilpack etc etc to see where your not getting power, with a multimeter

for the fuel it could be as something simple as the fuel line in and fuel line return mixed up (done that before on a RB25 )



Another idea is to take your car to an auto electrician?