Beams is in - but won't start Options

[S8S8]

I've just finished converting my Aussie ST204 to Beams power using an ST202 SS-II clip, but I can't get the engine to start.

The engine turns over, but won't fire. We're pretty sure the problem is the fuel pump, as there is no fuel pressure. The relay on the ECU is operating, so the issue seems to be somewhere between there and the fuel pump. It was working fine with my old 5SFE just last week, so I'm sure it must be a wiring issue rather than an issue with the pump itself.

There are issues with wiring to the new instrument cluster too. It's way off, with all to wrong lights coming on for the indicators and high beam etc. The dash lights don't work at all either.

I'm not so worried about the dash issue at this stage, but thought I'd mention it on the off chance it could be connected with the non-starting issue.

Any assistance would be greatly appreciated.

[S8S8]

Thanks Rusty & Batman.

Everything is plugged in and there are no spare plugs or sockets. All fuses are fine and grounds are in place.

Just last night I was thinking about the front chassis loom. It hadn't occurred to me that I should change it since the fuse boxes are the same and everything plugged in fine, but I guess that's the last piece of the puzzle. So I'll change that today and see how we go.

One of the guys from Toymods mentioned the clutch switch as well. I can clearly see the switch on my car, but there is no such switch on the donor car, nor is there anything running from the loom. In that case, given that the switch is just sitting there with nothing running to it, it should be okay to just leave it there right?

Thanks.