Problem finding a exhaust manifold with T3 fllange, With wastegate flange Options

[Iceman22]

Hello.
My friend has bought a garrett turbo kit for his celica st205.
The turbo will have a external wastegate (42mm), now we got all the parts we need, including a T3 downpipe.

BUT, we are struggling with the exhaust manifold. We can't find any manifolds with T3 flange that fits this engine, also we need to have a hole for the wastegate.
We are desperately needing one but we can't find one, so now we are planning to use a after market manifold with CT20B flange. It can perhaps be used if we cut the flange, and make a T3 flange and weld it on the manifold, plus we need to drill a hole on it for the wastegate.
The problem is that it is much hard work and easier said than done.

So, I'm wondering if anyone know where I can get this T3 manifold for a reasonable price ? Is it possible ? I have found some on eBay but they are for the 2nd gen engine, but they are also without the hole for the wastegate.

What should we do ??

This post has been edited by Iceman22: May 19, 2011 - 7:33 AM

[delusionz]

Korban let us know how that manifold goes, I've ordered a bit of stuff from him and half of it is junk. But my flatmate runs one of those manifolds (that one on his AE92 3S-GTE and a 4A+T one on his AE92 4A-GZE FX-GT Corollas) he says they're fine, but then again he never drives those cars, whereas I drive mine all day every day so I had a custom 3S-GTE-T28 steampipe made up and ceramic coated

manifold cost $800

coating was about $200

220+GST for manifold, turbine housing and downpipe coated