 CANT BLEED CLUTCH LINE, can someone help |
 Jul 13, 2011 - 10:50 AM
|
 
|
|
Enthusiast  Joined Sep 22, '10 From pomona, ca Currently Offline Reputation: 1 (100%)  |
hey whats up every one, just recently i pulled out my motor, rebuilt it completely and installed a new clutch.
yesterday i finished dropping the engine back in the car, im almost done hooking everything up. i reconnected the clutch line back to the slave cylinder, but im not getting any pressure on the clutch pedal. i tried pumping the pedal multiple times, and then had someone open the bleeder valve but no fluid is coming out at all, the reservoir tank is full, and it worked fine before i pulled the engine out. i tried bleeding for about an hr with no luck. is there another way of bleeding the system? 
|
 |
Replies
|
Jul 15, 2011 - 6:20 PM
|
|
 Enthusiast Joined Dec 15, '02 From Tasmania(Australia) Currently Offline Reputation: 0 (0%) |
Had this issue with a mates ae82, it turned out to be the master cylinder.
In the time it was disconnected the seal must have hardened because it wasnt pushing fluid or much pressure. -------------------- ST205 Group A Rallye GT-Four, #61 of 77............600hp GT3582r
GRX133 Toyota Mark X 350s  |
Posts in this topic
batcavee00 CANT BLEED CLUTCH LINE Jul 13, 2011 - 10:50 AM
batcavee00 Anyone? Jul 13, 2011 - 5:14 PM Batman722 keep trying.
maybe the slave is bad. Jul 13, 2011 - 5:24 PM presure2 Mightyvac FTW
its a hand held vac pump make to ble... Jul 13, 2011 - 5:36 PM batcavee00 The vac sounds good. Ill give it a try. Ive heard ... Jul 15, 2011 - 9:22 AM
batcavee00 I got it to work after all, its easier to do it wh... Jul 16, 2011 - 6:18 PM |
5 User(s) are reading this topic (5 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: January 11th, 2025 - 7:57 PM |