Driveshaft trouble, have searched Options

[Cs91]

Hello,

In need of a bit help here. Have just swapped a 3SGE into my AT200. But the passenger side driveshaft keep popping out of the wheelhouse. Or it popps out of the CV joint. Have watched some diagrams on toyodiy, but cannot find out if there should be a snap ring in the joint there? Cause there are none in my driveshaft assembly atm. Anyone familiar to how this CV joint should be rebuild? I took it apart yesterday and rebuild it and regreased, but the new grease just made it pop out even quicker! So now the car is just sitting going nowhere. And i can't even find the partsnr. on toyodiy....

Anyone that could help me with this?

This post has been edited by Cs91: Aug 4, 2011 - 5:47 AM

[Cs91]

Thank you for the help guys, but i found out that my CV joint was missing a C-clip on the edge of the driveshaft that goes through the ball bearing. So there was nothing to keep the driveshaft from slipping through and out of the joint. Atleast i HOPE that is my problem. Got the ring from Toyota, and will try to install as soon as the rain settles...

Thanks again