Vibration under acceleration, anyone hear of this? Options

[aaronc222]

It's been a while since I've asked for help on here, but I finally have a problem that hasn't been asked about(to my knowledge).

Under moderate to heavy(full throttle) acceleration in 1st and 2nd I'm getting a nasty vibration through the steering wheel and floorboard. The front and rear motor mounts were replaced last summer, and I know one of the rims is warped(getting new ones when I get my tax return), but it doesn't feel like it could be a tire/wheel, even though it almost feels like wheelspin/hop.
I'm also hearing a clicking sound from the passenger front on low speed turns(20-30) mostly with my foot off the gas, it's seperate from the vibration, but still something I'll be looking to fix while I'm under the car.

Just wondering if anyone has had a similar problem so I can have a jumping off point before I get under the car(probably go with the jackstands instead of the ramp so I can have the tires out of the way). I've got Thurs-Fri off from work and plan on tackling this problem as well as installing my Blitz front end(if it's warm enough, otherwise it's just fixing the problem).

To me it sounds like it may be a CV joint or shaft, but just wanted to hear some opinions so I can have some key areas to look at while I'm under there.

ed: almost forgot, I've got ~196,700 miles on the car

This post has been edited by aaronc222: Feb 3, 2004 - 10:13 PM

[aaronc222]

So much for getting rims with my tax return. But it's better to have it running with curbed rims than not running with nice 17's(looking at either Enkei RPM2 or their new RSV). I can always wait a couple paychecks and still get the rims.

New development: Upon further driving(to and from work) I've found that right turns are ok, but left turns under throttle are getting the vibration. Although it's only right turns that make the click sound(and only occasionally, and it's very faint).

This post has been edited by aaronc222: Feb 5, 2004 - 1:35 AM