3rd Gen 3S-GTE Stroker, Will my chosen Piston/Rod/Crank combination work? Options

[Unicorn]

I'm in the process of designing a 2.2 stroker motor for a 'Four, and have made some part choices already. I'm hoping to start building the engine early (Q1) next year, so this is really just the R&D/planning stage. What I've chosen for the internals so far is as follows;

JUN custom stroker kit (Pistons & 17Kg crank. PN 1029M-T001)
JE Forged pistons @ 86mm bore for 3SGTE (PN 298701)
Eagle forged H-Beam 138mm rods (PN CRS5428T3D)

My question about these is whether or not the JE pistons will work with the rods and crank that I've chosen. I read somewhere (on alltrac.net I believe) not too long ago that the pistons supplied with stroker kits are actually stroker pistons, with the wrist pin slightly higher in the piston so that it doesn't extend past the deck on the block and crash into the valves. I'd like to have the option of using the JE pistons instead of the JUN kit supplied Cosworth ones, then sell whichever set I don't use - but are the JE pistons manufactured to accommodate a stroker crank?

As far as the rest of the parts go, I'm not sure yet, still need to think about what I'm going to use in the head - High lift cams, valves, springs etc. And I haven't really thought about what manifold I'm going to use yet either, although I know what turbo I'd like to use at this point.

The engine will be going in a weekend drive/trackday car. I'd like to start off hitting 400hp after the rebuild and then work from there, getting as much power as I can out of it for a track map.

Any thoughts and advice would be greatly appreciated

[99gt3sge]

man that sucks, its like here in the US we got the water down version of the celica! everyone else got the gt4 but us. and as far as the flywheel its the same bolt pattern, but i think the earlier models might have been diffrent bolt patern.