 *HELP* Rod Separation From Piston, how do you do it? |
 Dec 21, 2011 - 6:39 PM
|
 
|
|
Enthusiast  Joined May 11, '09 From California Currently Offline Reputation: 4 (100%)  |
I need to replace my rod(broke the bearing). How do i separate the rod from the piston? Similarly, do I need to hone the cylinder if i am replacing the piston with a piston from another 7AFE? (i think its yes, but i just want to make sure) Help is greatly appreciated, i gotta get her running by the end of the week. . .
-------------------- |
 |
Replies
|
Dec 21, 2011 - 7:38 PM
|
|
 Enthusiast Joined May 4, '05 From western MD/NOVA Currently Offline Reputation: 2 (100%) |
nope. sorry to say, but the 7afe pins are pressed in. quite aggrovating since most other are held in by a clip..
yeah you are going to have to press the old pin out and then have the new one pressed back in.. and as long as the other piston is of the same "mark" designation for piston diamiter/ bore then you should be ok.. just make sure it is the same.. say. post a pic of the top of the piston if you can. -------------------- |
Posts in this topic
DST94 *HELP* Rod Separation From Piston Dec 21, 2011 - 6:39 PM
Cuts_the_Pilot There is a circlip on the piston holding the gudeg... Dec 21, 2011 - 6:57 PM
DST94 QUOTE (Cuts_the_Pilot @ Dec 21, 2011 - 3... Dec 21, 2011 - 7:31 PM Smaay take it to a machine shop, they will heat it up an... Dec 21, 2011 - 7:56 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: January 12th, 2025 - 7:43 AM |