 Help!! GT4 brake conversion issue |
 Jan 18, 2012 - 11:58 PM
|
 
|
 Enthusiast  Joined May 11, '10 From Australia Currently Offline Reputation: 2 (100%)  |
Hi all,
I just noticed an issue with my front brakes.  This is happening to the inner and outer pads on the front brakes. Could it be that I have the wrong pads, or the rotors have been machined down more than 300mm. Also I noticed that on turns the ball joints come in contact with the rotors. I can clearly see the marks engraved on the front rotors from the ball joint. Would anyone know what is the cause of these 2 issues? |
 |
Replies
|
Jan 20, 2012 - 10:28 AM
|
|
 Enthusiast Joined Mar 8, '04 From Newport, RI Currently Offline Reputation: 63 (99%) |
He is right, to a degree.
My 205 rotors are trimmed to 300mm and I have supra pads. The outer pads fit 100% perfectly but my inners sit a few mm lower than the outers. Just to be safe I trimmed off a few mm from the bottom of the inner with my grinding wheel and good to go. Also, my rotors do not hit my ball joint. I put new ball joints in a about 2 years ago and I don't have my car sitting too low. Both of those things could cause the rotor to hit. -------------------- |
Posts in this topic
PL-41-ER Help!! GT4 brake conversion issue Jan 18, 2012 - 11:58 PM
njccmd2002 the problem with your conversion, is that its cust... Jan 19, 2012 - 1:24 AM playr158 It would also help if you told us what your setup ... Jan 19, 2012 - 9:22 AM PL-41-ER My setup:
- New DBA Rotors machined to 300mm
- Ne... Jan 19, 2012 - 7:43 PM
 |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: December 4th, 2024 - 12:05 AM |