6G Celicas Forums

Welcome Guest ( Log In | Register )

> Ecu just replaced, still running rough
post Feb 24, 2012 - 6:06 PM
+Quote Post
CrypticDeity

Enthusiast
*
Joined Feb 17, '12
From Scranton
Currently Offline

Reputation: 0 (0%)




I just replaced the ECU and my car is running now. It's still running rough/shaking just like it did before the ECU died though. I am not driving it because I am worried something else might cause this ECU to break as well. Is the some type of voltage control module for it or something?
 
Start new topic
Replies
post Feb 24, 2012 - 8:13 PM
+Quote Post
bsamps4

Enthusiast
****
Joined May 16, '10
From Raleigh
Currently Offline

Reputation: 12 (100%)




I'd be sure to check all you're grounds to make sure there isn't a short of some kind. Time to bust out the volt meter and get busy I'm afraid, but you also never mentioned the full story that led up to you changing the ECU. A full symptoms list is crucial to us helping you fix your problem.


--------------------
post Feb 24, 2012 - 8:29 PM
+Quote Post
CrypticDeity

Enthusiast
*
Joined Feb 17, '12
From Scranton
Currently Offline

Reputation: 0 (0%)




Well it ran fine until one day it started running rough, stalled, then wouldn't start. The fuel pump wasn't getting power. I replaced it and it works again but is still rough. There really weren't any symptoms until just before it happened. It was a dry somewhat colder day but not colder than usual. Just filled tank with 87 octane. Had no prior work done to it. oil changed about 2000 miles beforehand. I need to get a carfax report still.

Posts in this topic


Reply to this topicStart new topic
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: February 22nd, 2025 - 10:07 AM