Projector Retrofit!, Finally Done! Options

[smkr3w]

***UPDATE***
Check PAGE 2 for Completed Pics!



Finally started work on putting together some projector headlights.

I started out with buying used/not installed Rayme Lenses.
And a spare set of low headlights to do work on.

Months later, last week I purchased Morimoto Mini H1's from TheRetrofitSource.


I was playing around with ideas for shrouds, and tried my hand at vacuum forming.. not bad I guess.

But I'm going to try something else.

Today I got antsy and had to try em out.. took awhile to remove the bumper kind of a PITA
*Note: Shrouds and Clear Lenses not installed yet*



Upclose


Against the garage the light pattern difference is obvious.


Both.. NOT adjusted yet!


This post has been edited by smkr3w: Jun 13, 2012 - 9:24 PM

[smkr3w]

Looks good!

Thanks!

what'd you use to get the projector assembly to stay in place in the housing? and what are the projectors out of? I am trying to do the same with some out of an rx350

The projectors aren't from anything. They're special made for retrofitting. So the thread on the back side of the projector sits snuggly inside the original bulb hole and is tighten buy a nut that is seated perfectly in the back
Here: