![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() Joined Jul 5, '12 From Barcelona Currently Offline Reputation: 0 (0%) ![]() |
My names Ed, and I live in Barcelona, Spain. I am from the Republic of Ireland. I've been living here for 13 years. In that time I've had a number of cars.
First one I got a year after arrival was a '93 Prelude 2.2 vtec. After that I got a '00 BMW 318ci. I sold that to get back into university. So now I've got this 1996 GT. Its covered in dents and scrapes. Pretty tired looking. I want to make it look like new, improve it where I can and try to keep it as standard as possible. I'll be painting it black, and keeping the wheels as they are, just tarting them up a bit. All of this depends on my finances of course, so it'll be a slow process. Patience will be required. Lots of patience. ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() This post has been edited by Edser: Jul 21, 2022 - 5:58 PM -------------------- ![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() Joined Jul 5, '12 From Barcelona Currently Offline Reputation: 0 (0%) ![]() |
Here's some more photos of progress.
I took off the side skirts - it was very easy. The rear wing was a bit more complex, had to remove a small plate that was covering the central bolt. The I discovered the wing was glued on as well, so I had to cut away at the glue. That was so difficult to clean off afterwards. Quick 2 min walk around of Celica, showing some of the many flaws. I've seen cars in scrapyards that look better. https://www.youtube.com/watch?v=ZmNqihypO-4...;feature=relmfu This me sanding away to get rid the lumps and only leave the sexy humps. Good tip when filming, don't leave a glass of water on the ground where it can get kicked. https://www.youtube.com/watch?v=WvBQr49PEs8&feature=plcp ![]() ![]() ![]() ![]() ![]() ![]() ![]() I got some good and bad news today too. I went to talk to the owner of a garage here in this small town, and he said I could paint the car using his spray room. Bad news is that the paints he uses are expensive, and could cost over 500 euros. Still, if I can get a top quality finish it'll be worth it. There's rust on the rear boot lid (Trunk in American!) so I'll get him to take the glass out of the rear lid and weld in some fresh metal. I'm not sure if I should take out the front wind shield for painting as well. My Sleeeka also has the usual clack clack clack when turning left with the foot on the pedal. So I think that's one of those drive shafts jumping. So I'll get the mechanic to put in a reconditioned one. Apparently it's a lot cheaper. ![]() This post has been edited by Edser: Jul 9, 2012 - 9:25 AM -------------------- ![]() |
![]() ![]() |
Lo-Fi Version | Time is now: August 24th, 2024 - 3:51 PM |