UPGRADED the lower control arm bushings, the a-arm bushings Options

[Batman722]

I was going to do a how-to but was too caught up with just getting this done, I only snapped a couple of pics at the end.
Me, Manny, and Stef knocked this out pretty easy.

I ordered some front suspension bushings from Paul in Poland



here's a pic of the control arm



(taken from this post)

I went from this bushing



to this bushing



and the other



I know the pics I took kinda suck (they're a little messy from the grease too) but I was more concerned about feeling the difference driving with them and then eating.

I have to say after launching a few times on the ride home I can really feel the difference with keeping the wheels on the ground. They really help to reduce wheel hop and it feels great.
The other thing I wicked noticed was how much tighter the front end feels during turns. They keep the front end of the car much more level to the ground and cornering is so much more controled, it's amazing.

also, ride quality was not compromised at all, which I was a bit concrened about.

The entire process took a few hours and air tools made it much easier

This post has been edited by Batman722: Jun 30, 2009 - 8:22 AM

[ricochet1490]

you should just bring these things to ohio.... LOL nothing wrong with 5 celicas and 3 beams in the garage at once bro

When dropping the subframe for the race car, 3 of the bolts on each side go int o the frame rail.... one bolt threads into a welded nut that is just welded to some thin sheet metal that has a high tendancy to rust out... that welded nut snapped off the sheet metal on each side, not a big deal cause its a track car and the other three bolts go into FRAME instead of just sheet metal.... prolly won't even put it back in.... dunno if this is the bolt you're talking about or not