Oil leaking from Input Shaft Seal?? 2nd Time replacing, Is something bent, or what???????? :/ Options

[injection]

Hey fellas, just had my new input shafts installed, and new seals as well, couple days of driving, and one seal is leaking bad! Like 6 inch puddle of gear oil I'n about 30secones bad!,
This is the second time I have replaced the seals, and still leaks, and I just had new Input Shafts installed as well, other ones were make thud sounds on lefts.......I am using the 5s tranny ( fwd ) with the st205 engine, have 285,000 KMs on the original GT tranny, a stage one clutch installed, and syncrohs feel really nice as well, any ideas why my seals keep blowing out?? I was told these trannys mate well with the st205, as long as your not tearing up the streets 24/7.... I'm thinkin something could be bent on my tranny, I think, or is there a tougher seal out there I can install???? Thanx fellas!

PS. The Input Shafts are the stock ones for the 5s Tranny of course, and the seals too

[TerBeau]

im having the same exact issue. go under your car shake your axle up and down. it move like that because your bearing is shot. in my case its the driver side. i installed new seals because mine was leaking badly also. but even though new seals were installed it continued to leak because the bearing inside wobled the axle while driving wearing the new seal and no longer sealing agin. so i got another trans and bulding this one to install this one in place of the old one.