![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() Joined May 30, '12 From CA/NV Currently Offline Reputation: 0 (0%) ![]() |
So I've had my car for three months now and still cannot figure out what this noise is! I'm by no means a mechanic but have common sense around cars, celicas inparticular. It's a mostly stock 7a-fe with 194k and 5 spd tranny. The car runs fine, and since I've had her changed the oil, spark plugs/wires, exhaust manifold/down pipe(original was cracked), and have had no other problems...not even a check engine light. I can't find anything loose that would rattle, but there is a significant power steering fluid leak.
http://youtu.be/FOrH0HC7l5w Please see the video I put on youtube to hear the noise, which is most notable on a cold start and anytime I'm constantly holding revs over 2500rpms, but will stop if I floor the gas or let off it completely...It's very annoying on the freeway(but isn't noticable with the radio on! ha!). I'm thinking maybe a bad piston ring, or possibly something in the fuel injectors??? I should also say the noise does seem to emit from the passanger side of the engine bay. I'm worried it may be time for a rebuild as I do not know how the previous owners treated her. ![]() ![]() -------------------- 2004 Celica GT-2zz w/6-speed swap
1999 Celica GT-3sgte swap 1993 Celica All-Trac 1997 Celica ST/Limited-rip 1993 Celica GT-rip my first love |
![]() |
![]() |
|
Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Dec 8, '03 From Lancaster CA Currently Offline Reputation: 6 (100%) ![]() |
^^^ since you have a ST you should upgrade to a V6, not a crappy 3S-GTE that is too expensive.
now back on topic. Erynns car did the exact same thing. when i pulled it apart, this is what i found. ![]() all the bearings looked like this. luckily the crankshaft was fine. it just needed a polish and it cleaned up perfectly. -------------------- 2001 Celica GT-S Turbo
1997 Supra TT 6speed 1997 Celica 3MZ/1MZ swap 1990 Celica All-Trac |
![]() |
|
Enthusiast ![]() Joined Jun 20, '12 From Tucson, az Currently Offline Reputation: 0 (0%) ![]() |
^^^ since you have a ST you should upgrade to a V6, not a crappy 3S-GTE that is too expensive. now back on topic. Erynns car did the exact same thing. when i pulled it apart, this is what i found. ![]() all the bearings looked like this. luckily the crankshaft was fine. it just needed a polish and it cleaned up perfectly. what v6 are you talking about??? |
![]() ![]() |
Lo-Fi Version | Time is now: February 18th, 2025 - 8:46 AM |