6G Celicas Forums

Welcome Guest ( Log In | Register )

> No power after 5s to 5s swap., kinda sucks, need help.
post Sep 20, 2012 - 3:57 PM
+Quote Post
Spider77



Enthusiast
*****
Joined Jan 17, '08
From JB MDL, NJ
Currently Offline

Reputation: 30 (100%)




Ok, so the engine is swapped over, learned somethings to hate, but besides that I have no power. I put the key in, turn it to ACC and nothing, turn to start and I can hear the relay clicking by the ECU. The only thing that works is lights. Thats it, no radio, no climate control, no cluster panel, and more importantly the car wont turn over. I even went so far as to replace my ecu and relay, but im in the same boat. My battery is good, rechecked my grounds, checked fuses...all good.
So Im at a loss here. Its kinda my DD so I need it up and running.
Thanks
 
Start new topic
Replies
post Sep 20, 2012 - 7:18 PM
+Quote Post
Special_Edy



Enthusiast
****
Joined Oct 29, '11
From Haltom City, Texas
Currently Offline

Reputation: 1 (100%)




There are 4 grounds that I know of on the 5SFE,
on the top of the transmission, under the airbox
on one of the bolts holding the bellhousing to the engine block, the very top bolt under the distributor.
Near the alternator, going from the passengerside strut tower to the cylinder head
final one is on the back of the intake manifold, it goes into the fuel injector harness.

If any one of these grounds is disconnected the car wont start and run.


I can swing by and take a look at it tomorrow if you shoot me a pm.

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: February 21st, 2025 - 9:47 AM